jaymonkey
Moderator
- Joined
- Aug 27, 2011
- Messages
- 4,080
- Motherboard
- GB Z490 Vision D
- CPU
- i9-10850K OC @ 5.2 GHz
- Graphics
- RX6800-XT+UHD630
- Mac
- Mobile Phone
I am attempting to install 10.11.6 on my HP 13-y013cl. I am struggling with the NVME drive as it is not detected in Disk Utility after booting off of the install USB. I have generated the correct HackrNVMeFamily kext using RehabMan's method, as well as created the SSDT_NVMe-Pcc.aml file. I also have _DSM to XDSM replacement setup in the config.plist. I removed all references to the IONVMeFamily.kext patches in the config.plist. I do not know what else to try.
The NVME drive is a Samsung MZVLV256HCHP-000H1.
Please let me know if any of you have any suggestions. Thank you for your time.
Hi
I have the same nvme on my 2017 15" HP Spectre X360 and had a similar issue .... a few suggestions :-
Firstly why are you using 10.11.6 ? .. suggest you use 10.12.6 as your kaby lake CPU & GPU are natively supported ... to use 10.11.X you will have to spoof the CPU & GPU .. see the guides elsewhere on this site for more info on spoofing KBL as SKL.
Have you patched your DSDT ?
Try adding NvmExpressDxe-64.efi to /EFI/Clover/drives64UEFI .... its in the Clover install bundle .. normally only installable when using legacy (mbr) install but if you use pacifist you can extract it manually ... i was unable to use nvme without it.
The clover IONVMeFamily kext patches are basically the same thing as rehabmans HackrNVMeFamily .... his script applies all of the patches to the apple kext and saves it as HackrNVMeFamily... use one method or the other but not both.
Be sure to use the class-code spoof SSDT so that HackrNVMeFamily can co-exist with the apple kext ..
When trying to install osx the first time to a new laptop i always install to a usb SSD (or HDD) ... get that booting first and debug the osx install ... once running correctly use carbon copy cloner to clone the build onto a partition on your nvme.
Good Luck
Jay