Updated Clover and Now I can't boot

[cannfoddr]

Hi,

I just updated clover to the latest version and tweaked my config to disable SIP in preparation to sorting out my Audio drivers following 10.11.6 - I've done this before many times.

Upon rebooting I am presented with the usual clover menu and I choose my OS X partition and everything seems to go fine up to the point where I would normally expect a login prompt....

I now get a Fuzzy El Capitan screen with no login "faces" prompt or anything.

I changed the SIP mode from 0x0 to 0x67.

Whats my best way to proceed?

 

[cannfoddr]

Ignore this it was actually booting fine...

For some reason that I don't quite understand the update to clover seems to have done one of the following, not sure which yet:

• Suddenly the HD 4600 graphics has started working and this is the primary video card and the login display was showing on that adaptor - proved this by plugging my monitor to the internal DVI port
• The HD 4600 was always working and was the second adapter as specified in the EFI setup with the login prompts always appearing on the Nvidia card which has the monitor connected but the change somehow mode the HD4600 primary

For now I've fixed this by removing inject_intel from my clover config.