System boots only with safe mode

[ultimatemosler]

• Use TextEdit to edit the org.chameleon.Boot.plist (see attached file)
Novi

I've had the same problem whereas it will only boot to Mountian Lion in Safe Mode. This is my first build and I know absolutely nothing about programing. I've been running my display through the motherboard and run "GraphicsEnabler=No -x" at bootup. Another problem I see is that my intel CPU is locked in a clock ratio of 28 running at 2.8 ghz... I have the same processor as you. I haven't taken any of the steps you've prescribed yet, because it took me forever to even get to this point. If it makes much difference, I ran Multibeast 5.0.2 instead of the version you have. I'd like to get out of the safe mode nonsense, get my graphics card recognized, and get my CPU up to the clock speed it is supposed to be at. I'd love some advice in terms that a monkey could follow!

GA-Z77X-UP5 TH
EVGA GeForce GTX-670 4gb
Intel Core i7 3770
Running 8gb of Corsair Vengence RAM, but have 24gb on standby to add in.
OCZ Agility 3 120gb SSD

 

[jmpa]

I've had the same problem whereas it will only boot to Mountian Lion in Safe Mode. This is my first build and I know absolutely nothing about programing. I've been running my display through the motherboard and run "GraphicsEnabler=No -x" at bootup. Another problem I see is that my intel CPU is locked in a clock ratio of 28 running at 2.8 ghz... I have the same processor as you. I haven't taken any of the steps you've prescribed yet, because it took me forever to even get to this point. If it makes much difference, I ran Multibeast 5.0.2 instead of the version you have. I'd like to get out of the safe mode nonsense, get my graphics card recognized, and get my CPU up to the clock speed it is supposed to be at. I'd love some advice in terms that a monkey could follow!

GA-Z77X-UP5 TH
EVGA GeForce GTX-670 4gb
Intel Core i7 3770
Running 8gb of Corsair Vengence RAM, but have 24gb on standby to add in.
OCZ Agility 3 120gb SSD

1st- go to bios and do:
press F7 key- load optimized defaults

After check that guide:
http://www.tonymacx86.com/99-quick-guide-configuring-uefi-gigabyte-s-7-series-lga-1155-boards.html

2nd - take your gtx 670 out

3rd - connect hdmi or dvi (VGA dont work) on motherboard

4th - make a clean install, follow 10.8 oficial guide with the multibeast settings from that guide:
http://www.tonymacx86.com/attachments/27977d1352210395-mb-z77x-up5-th.png.html

5th - restart, check if everything is working well. If yes go to multibeast and do that:
http://www.tonymacx86.com/attachmen...epler-cards-work-graphicsenabler-no-ge-no.png

6th - turn off pc, connect your gpu and its working