pastrychef
Moderator
- Joined
- May 29, 2013
- Messages
- 19,460
- Motherboard
- Mac Studio - Mac13,1
- CPU
- M1 Max
- Graphics
- 32 Core
- Mac
- Classic Mac
- Mobile Phone
Oops. My mistake. Let me change that now. Thanks!
Is ASmedia 3.1 chipset now supported in macOS?...
2. You should NOT install 3rd party USB 3...
OK. I'll remove it and check the results. Thanks for your insight.
I've updated Post #1's MultiBeast configuration choices, removing the GenericUSBXHCI.kext from the Build list. If you have the GenericUSBXHCI.kext in your drive's /Library/Extensions/ folder, remove it to the Trash and perform the following commands in the Terminal:hey people! I need some help here.
After installing all soft- and hardware, I keep running into this problem.
- it started BIOS hanging up (black screen) when USB 3 ports where plugged in on start up.
- now BIOS won`t even load, when I start up with only USB 2 connected.
- when I do a CMOS reset, I can get all the way to macOS sierra but, on restart, it hangs up again before BIOS loads.
What did I do wrong? Sierra runs fine once started.
I followed Storks guide on page 1
sudo kextcache -system-prelinked-kernel
sudo kextcache -system-caches
That's because there is no serial port on this motherboard...and I can not find the option to disable the serial ports in BIOS.
No, idea what the cause/solution of the problem could be. Check the GENE's User Manual for the error code. (I think it might be something generic, though). I'm at a lost to tell you what to do.thanks Stork,
done that. works all fine on reboot, as soon as i shut down and boot again, same problem.. mobo error code 99.
any help would be so great !!!!!!!