Hi, michaiel
1 Remove mobo battery for few sec and put it back again
2 Remove everything that are connected to your PC except [Use Wired keyboard and mouse only]
3 if you have SLI , just keep one of your graphic cards on Only
4 Disconnect all hard drives and remove m.2 if its there . ( power cable and data sata cables )
5 use one Stick of your Ram in the first slot on the far Left . if didn't work out use the 2nd slot from far left
note : just keep the mobo connected with the power sub ( Two cables ) And one graphic card and one Ram as explained above and ofc cpu cooler on .. thats it
finally ..
1 prepare your Bios update file ready on USB
2 power up , and update your bios .. load opt only
3 shutdown .. then plug in whatever you had before while setting up your rams sticks properly by the book
Good luck
Thanks for reply...
Ironically I have have done this at various times for the last month with Gigabyte tech phone support....
I only have one GPU and have another one coming to try next.
What bugs me is that I asked them repeatedly why I never got any audible code(s) (beeps) out of the board. I assumed the mobo had a speaker built in for 420.00 and they assumed I already had a board mounted speaker. I finally realized I needed a speaker and ordered it.
I will update everyone when I get the speaker and GPU and figure this out.
THE MOTHER OF ALL F@#K UPS IS ASSUMING.....
Sorry Rocket, not trying to take over your thread and steal your thunder.....
it's works, that's rock
Thank's Rocket
So your issue is that you as soon as you power up your pc , it shut down correct ?
Check your monitor tbh and cables , try using another monitor perhaps your tvIt will IF I remove the CPU and RAM. If I have the RAM and CPU installed it will run indefinitely with a black screen
Check your monitor tbh and cables , try using another monitor perhaps your tv
Or using another ports hdmi dvi DisplayPort etc , borrow your friend graphic card to see if your current card is failing..