- Joined
- Mar 2, 2014
- Messages
- 2,051
- Motherboard
- Gigabyte Z390 I AORUS PRO WIFI
- CPU
- i9-9900K
- Graphics
- RX 580
- Mac
- Classic Mac
- Mobile Phone
Thanks wstrohm and Psimondo for your help. I managed to install OSX 10.11.2 using a Config.plist file with the changes suggested in http://www.tonymacx86.com/threads/10-11-0-10-11-3-skylake-starter-guide.179221/ using the USB port on the keyboard. Well, at least I installed. the problem now it that I don't succeed to boot from the SSD disk where OSX was installed. I stops for a while right after "AppleIntel1000e(Info): AppleIntel1000e:rx = 256, tx = 256", and gives me the prohibited sign after the line that follows, see on image attached. I downloaded and installed the 10.11.2 Nvidia drivers, gone back to step 4 and done all again, checked and rechecked. Dos anyone have any suggestions?
Do you have Multibeast 8.2.3 on your USB Installer flash drive? If not, find it and put it on the drive. Next, insert the flash drive into the computer port and boot from your SSD drive. That should work as long as the flash drive is in the port. Once you are booted on the SSD, double-click on the flash drive icon and run Multibeast. When you get into the Drivers menu, select "Network." Click the arrow next to "Intel." Check the box next to "IntelMausiEthernet v2.1.0d3." (The other choices are not appropriate for Skylake motherboards, I think.) Then go to "Build" and verify you have all the choices you want. Then click "Install" to your SSD. What other choices have you made for the Multibeast post-installation? If any of those choices are inappropriate, you will have trouble booting without the flash drive in a USB port.
I would repeat that you would be much better off installing the current version of the Mac OS, which is 10.11.6. There were many problems on Skylake with 10.11.x where x is less than 4.
Last edited: