- Joined
- Sep 3, 2011
- Messages
- 12
- Mac
- Classic Mac
- Mobile Phone
:?Sorry for my english, I'm from Russia ... :?
make sure you are using HDMI2 port under the USB (not VGA). You possibly have another AppleHDA kext in place. check and make sure you don't have an ALC8xx kext. you should only have the AppleHDA.kext (Beta 889) that Toleda posted a link to on the first page of this thread.sergey19687 said:All the good times of the day!
After installing the DSDT-GA-H67N-USB3-B3-F7-EHCI-HDMI.aml lost in the sound settings HDMI output and not working headphone output, is only the green line-out, written information about the system- ID of the audio: 889.
I'm using the Intel Core i-3 2105 with the HD-3000 with the connection to the TV instead of monitor.
Perhaps the audio ID should be 389, but how?
Thanks in advance ...
If you have the correct DSDT for HDMI on HD3000 and the correct AppleHDA kext, then your audio ID should be 389. Be sure and check your S/L/E folder and make sure there isn't another audio kext that is getting in the way.sergey19687 said:Kekst only AppleHDA.kext (beta-889) from Toleda, HDMA cable is properly connected ...
Yes, if you got it from the Toleda post in the front page of this thread. Rename it dsdt.aml and place it in /Extra folder. Make sure you've fixed permissions (run system utilities from Multibeast is one way to do that).sergey19687 said:Where to get the correct DSDT for HDMI on HD3000?
I believed that DSDT-GA-H67N-USB3-B3-F7-EHCI-HDMI.aml is the correct version of the latest ...
Thanks for the advice, it works!bc24 said:Yes, if you got it from the Toleda post in the front page of this thread. Rename it dsdt.aml and place it in /Extra folder. Make sure you've fixed permissions (run system utilities from Multibeast is one way to do that).sergey19687 said:Where to get the correct DSDT for HDMI on HD3000?
I believed that DSDT-GA-H67N-USB3-B3-F7-EHCI-HDMI.aml is the correct version of the latest ...
Nope.idezine123 said:Has the artifacting issue been resolved for the Custommac minis yet? I built one and still have major artifacting, especially using the new Final Cut. Drives me nuts.
Tried looking back through posts and did what was suggested:
-480mb shared video RAM for onboard graphics with 8GB RAM.
-HPET 64 bit mode
-SATA to AHCI mode
My setup:
Processor: Intel Core i5 2500
Motherboard: Gigabyte GA-H67N-USB3-B3
CORSAIR 8GB DDR3
APEX MI-008 Mini-ITX
10.7.3 installed with Unibeast