- Joined
- May 31, 2014
- Messages
- 1
- Motherboard
- Dell
- CPU
- C2D
- Graphics
- nvidia
- Mac
- Classic Mac
- Mobile Phone
Hi,
Ran fairly typical unibeast & multibeast install on the Dell 220s vostro, works fine, but when
I replace the 2ghz C2d with an E5450 Quad Harpertown OS X won't boot anymore - screemshot below.
The E5450 is modded as per http://www.delidded.com/lga-771-to-775-adapter/ and with that chip
on board Windows 7 runs fine, no problems.
System definition is set to Mac Pro 3,1 which is when Apple started using the Harpertown quads.
However, Apple used the 1600mhz FSB Harpertowns and this the 1333mhz (max FSB of the Dell motherboard) if that is relevant.
Have tried many bootflags.
I would appreciate any help, or suggestions.
Ran fairly typical unibeast & multibeast install on the Dell 220s vostro, works fine, but when
I replace the 2ghz C2d with an E5450 Quad Harpertown OS X won't boot anymore - screemshot below.
The E5450 is modded as per http://www.delidded.com/lga-771-to-775-adapter/ and with that chip
on board Windows 7 runs fine, no problems.
System definition is set to Mac Pro 3,1 which is when Apple started using the Harpertown quads.
However, Apple used the 1600mhz FSB Harpertowns and this the 1333mhz (max FSB of the Dell motherboard) if that is relevant.
Have tried many bootflags.
I would appreciate any help, or suggestions.