- Joined
- Jun 13, 2017
- Messages
- 3,336
- Motherboard
- Gigabyte A520i AC
- CPU
- Ryzen 7 4700G
- Graphics
- Radeon Vega 8
- Mac
- Classic Mac
- Mobile Phone
Dell 7010 Ivy-Bridge
Core i7 3770
HD 4000
4GB Ram
Dell 250W PSU
CPU fan
1 TB FireCuda SSHD Catalina 10.5.3
Cardboard
Obviously this is just for fun! and it's NOT meant as a serious build, it's probably not recommended at all. But it was a silly project that was completed in a couple of hours and it didn't cost anything. The 250W Dell PSU enclosure is just a three sided box with two card beams holding it up off the floor, they also act as feet and stop it falling over. The two pieces above the PSU hold up the motherboard, not very well admittedly. The beams holding up the PSU and the mobo frame could of been one piece, that's for phase 2 of my build. The side panels and top are all one piece which slots into the back of the mobo frame and wraps over the top and slots in place. Did I mention I didn't use glue!. The front and back panel haven't been started yet, I have to cut the rear IO for the rear and find a way to mount the front case fan.
Core i7 3770
HD 4000
4GB Ram
Dell 250W PSU
CPU fan
1 TB FireCuda SSHD Catalina 10.5.3
Cardboard
Obviously this is just for fun! and it's NOT meant as a serious build, it's probably not recommended at all. But it was a silly project that was completed in a couple of hours and it didn't cost anything. The 250W Dell PSU enclosure is just a three sided box with two card beams holding it up off the floor, they also act as feet and stop it falling over. The two pieces above the PSU hold up the motherboard, not very well admittedly. The beams holding up the PSU and the mobo frame could of been one piece, that's for phase 2 of my build. The side panels and top are all one piece which slots into the back of the mobo frame and wraps over the top and slots in place. Did I mention I didn't use glue!. The front and back panel haven't been started yet, I have to cut the rear IO for the rear and find a way to mount the front case fan.
|
|
Last edited: