Kernel panic on first boot after 10.9 instalation

[jan_matejko]

Hi.
I am just upgaradig 10.7.5 > 10.9.
Everything goes fine (with GraphicsEnabler=Yes) until 10.9 instalation.
Instaled sucessfuly, I restart, boot with USB to Maverics and ... kernel panic (as in attached file).

Any help please.

Core i7
GeForce GTX 460
Sabertooth X58

 

[WonkeyDonkey]

Hi.
I am just upgaradig 10.7.5 > 10.9.
Everything goes fine (with GraphicsEnabler=Yes) until 10.9 instalation.
Instaled sucessfuly, I restart, boot with USB to Maverics and ... kernel panic (as in attached file).

Any help please.

Core i7
GeForce GTX 460
Sabertooth X58

I see you are using Macpro5,1 definition.

Did you delete AppleTyMCEDriver.kext from S/L/E before reboot ?

 

[jan_matejko]

Hi.

Do you advice to change to 3,1 or delete AppleTyMCEDriver.kext from S/L/E ? Or both.

 

[conelso]

What if u run cpus=1

 

[jan_matejko]

Thank you guys, but

deleting AppleTyMCEDriver.kext
chanaging to 3,1
cpus=1

all these does not solve the problem

heeeeelp...

 

[boschrenier]

Hey, have you tried without the npci=0x3000

 

[jan_matejko]

with or without npc=0x3000 the same problem ...

How can I run Mulibeast with no booting to 10.9?
I have a backup copy of 10.7.5, but Multibeast for 10.9 does not run.

 

[boschrenier]

Does it KP after Multibeast or before, if its after multi beast you should maybe try doing minimum manual selection of drivers as in DSDT Free and deselect all the options that aren't grayed out and then select boot loader and your GraphicsEnabler=yes and reboot to see if that works and take it slow to find the cause of the KP

 

[jan_matejko]

KP is before Multibeast,
after successful 10.9 instalation (installed with UniBeast).

I can boot to installer and install (with GA=Yes)
but I can not boot to 10.9, to run Multibeast.

Can anybody read this KP screen (in attachment), and tell anything from this?

 

[boschrenier]

KP is before Multibeast,
after successful 10.9 instalation (installed with UniBeast).

I can boot to installer and install (with GA=Yes)
but I can not boot to 10.9, to run Multibeast.

Can anybody read this KP screen (in attachment), and tell anything from this?

1. Have you tried booting with -x if you can get into osx in safe mode, Multibeast will fix the IntelCPUMonitor panic
2. Have you tried a clean install, could be some of the old drivers causing the panic