I'm pretty sure k1100 is working when it is standalone (reports were working OOB).
Things get tricky when combined with Intel integrated graphics.
I've spent some time trying a few combinations of settings, but sadly, I haven't found anything that would bring the system up with a detected k1100 nvidia card (unless I'm doing it wrong?).
There are a few settings in the bios and one of them seems to indicate it's possible to boot without intel;
Hybrid Graphics with 3 choices:
*
Enabled
*
Disabled
*
Auto
Not quite sure what Auto does but results were the same as Enabled. When I start clover with
Enabled, in
Graphics Injector Menu, it detects
two cards.
When booting with
Disabled, it
only detects K1100 card in injector menu. I tried booting with most of the configs combinations (InjectEDID, InjectNvidia, Generic NIVIDIA name, LoadVideoBios), took a while, but none of them gave me a nvidia card showing in system report. At this point, I don't know what I could try, what's important in these settings? FakeID? DisplayCFG, etc.
I also tried with
nvda_drv=0 and
nvda_drv=1 bootflags. In some cases, computer booted on black screen, I remote controlled it to see if it detected something, but nothing at all showed up instead of a 3mb builtin gpu intel.
I also found out that resolution was by default better and not stretched inside clover and verbose mode when booting with
UEFI Native (Without CSM) instead of
UEFI Hybrid (With CSM) in
Boot options . But trying only k1100 + UEFI Native glitched the screen and did not continue.
Feel free to suggests things to try. I did not try to DSDT patch manually yet.
Since I had bios open, I updated it and took pictures of all the settings available in case it could be helpful.
Boot options
Port Options
This one is a bit interesting as it talks about mdp, but I don't think it can help
Device configurations
Built-In Device Options