Help with core I5 7400 on Asrock 270m Pro4

[MAdb3AR]

so you can boot with usb stick and choose to run macos from hard drive ok?

ok

 

[Feartech]

ok

it was a yes or no question

 

[MAdb3AR]

so you can boot with usb stick and choose to run macos from hard drive ok?

This is boot process


And heres a new kind of panic

 

[MAdb3AR]

it was a yes or no question

Ah, the answer is that I can't boot either OSX installer or OSX from SSD

 

[Feartech]

Ah, the answer is that I can't boot either OSX installer or OSX from SSD

ahh, as you said a few pages ago that you managed to install macos and was trying to install clover to the hard drive

 

[MAdb3AR]

ahh, as you said a few pages ago that you managed to install macos and was trying to install clover to the hard drive

Yes)
Booting old version of OSX (10,12,X before 10.12.6) with SkyLake CPUID was successful and I installed OSX.
After installation of OSX, Ive installed CLOVER to boot Volume, rebooted PC, Booted from SSD and started to update OSX to 10.12.6, because it has native support of KabyLake. Before updating, I put # before fackeCPUID in clover on BOOT volume. Stated update, OSX has updated and here we are... Panic, panic, PAAAAANIC!

 

[Feartech]

Yes)
Booting old version of OSX (10,12,X before 10.12.6) with SkyLake CPUID was successful and I installed OSX.
After installation of OSX, Ive installed CLOVER to boot Volume, rebooted PC, Booted from SSD and started to update OSX to 10.12.6, because it has native support of KabyLake. Before updating, I put # before fackeCPUID in clover on BOOT volume. Stated update, OSX has updated and here we are... Panic, panic, PAAAAANIC!

try booting with your fakeCPUID and upload picture if you get a crash

 

[MAdb3AR]

try booting with your fakeCPUID and upload picture if you get a crash

 

[Feartech]

View attachment 284443

make sure BIOS Settings:

Load UEFI Defaults : Yes
Intel Virtualization Technology : Enabled
Primary Graphics Adapter : PCI Express
Vt-d : Disabled
IGPU Multi-Monitor : Disabled
Legacy USB Support : Enabled
PS/2 Simulator : Disabled
XHCI Hand-off : Enabled
Secure Boot: Disabled
Fast Boot: Disabled
Boot From Onboard LAN: Disabled

also try the attached config.plist

 

[MAdb3AR]

make sure BIOS Settings:

Load UEFI Defaults : Yes
Intel Virtualization Technology : Enabled
Primary Graphics Adapter : PCI Express
Vt-d : Disabled
IGPU Multi-Monitor : Disabled
Legacy USB Support : Enabled
PS/2 Simulator : Disabled
XHCI Hand-off : Enabled
Secure Boot: Disabled
Fast Boot: Disabled
Boot From Onboard LAN: Disabled

also try the attached config.plist

UEFI check done.
With this CFG it boots
But some soft doesn't work and it falls into panic in some time
Maybe I should try to reinstall it?