- Joined
- Apr 14, 2011
- Messages
- 498
- Motherboard
- MSI PRO Z690-A DDR4
- CPU
- i7-12700K
- Graphics
- RX 6800 XT
- Mac
- Mobile Phone
Sleep is working for me on my 1060. In my clover Boot -> Arguments I have dart=0 darkwake=8, not sure if that matters. Sleep is so dicey on hacks that I'm always afraid to mess with anything or I'll break sleep. I think I have my 1060 as primary in the BIOS? You might try changing that if you have iGPU to primary or vice versa. At one point in the 10.11.x days sleep only worked on AMD GPUs if the iGPU was primary. It's a lot of trial and error.
I don't have any knowledge about getting your monitor's built-in USB hub working at USB3 speed. If you followed post #1 instructions about generating the USB aml for your system and disabled the 15 port limit patch, and you look in System Report are the USB ports being properly tagged as USB2 or 3, if you plug stuff into them? And you plugged your monitor's USB out to a USB 3 in but the hub is still at USB 2 speed? Yeah I don't know how to fix that. Might check for other posts under post-installation forum.
I don't have any knowledge about getting your monitor's built-in USB hub working at USB3 speed. If you followed post #1 instructions about generating the USB aml for your system and disabled the 15 port limit patch, and you look in System Report are the USB ports being properly tagged as USB2 or 3, if you plug stuff into them? And you plugged your monitor's USB out to a USB 3 in but the hub is still at USB 2 speed? Yeah I don't know how to fix that. Might check for other posts under post-installation forum.