So I'm a bit at a loss here, after following this guide exactly - and then looking for other issues.
Problem: machine will not complete setup after install, verbose mode
either A (most common):
reports error:
OSX error allocating 0x119bb pages at [memory address] alloc type 2
Couldn't allocate runtime area
or B:
completes initial boot, moves to post-install setup, and immediately reboots, next boot is always followed by the above
Specs:
System: NUC8i7BEH
Memory: 2x8 Corsair Vengeance (DDR4-2400)
Drive: Samsung 970 EVO 250GB (NVMe)
This is really just bizarre. I can get through the install process but on final boot to complete setup, I just get the above errors. Any advice would be welcome.
Edit:
Another bizarre (possibly red herring?) addition to the situation - this seems to be time related. If I boot the NUC to clover, and then wait for 2-3 minutes (haven't narrowed the timing exactly yet) and then complete booting to OSX, I can boot no problem. Any sooner than that, and I just get the above error. This is consistent, however. I can't boot OSX immediately after system startup, but I can after a few minutes.