Contribute
Register

[Guide] HP ProBook/EliteBook/Zbook using Clover UEFI hotpatch (10.11)

Status
Not open for further replies.
on Hp ProBook 450 G3 Skylake

BIOS
Advanced>
Power Managment Options >
Disable Extended Idle Power States :: it causes system to not boot up and require you to remove the battery and the charger to be able to boot again
Disable Deep sleep .

Another Tip
if no USB customization found for some reason the same behavior will appear of system not booting until EC reset . *90% confirmed*
 
Last edited:
mo7a1995 said:
on Hp ProBook 450 G3 Skylake

BIOS
Power Managment Options > Disable Extended Idle Power States :: it causes system to not boot up and require you to remove the battery and the charger to be able to boot again
Power Managment Options > Disable Deep sleep .
Click to expand...

Just to clarify: the two options are in "Power Management Options", and named "Extended Idle Power States", and "Deep sleep", and should both be set to the "Disabled" state?

Is "Power Management Options" under a specific category, or is it a main category by itself?
 
RehabMan said:
Just to clarify: the two options are in "Power Management Options", and named "Extended Idle Power States", and "Deep sleep", and should both be set to the "Disabled" state?

Is "Power Management Options" under a specific category, or is it a main category by itself?
Click to expand...
yes they both should be set to "Disabled" state (remove check mark) .
Edited my post for clarification .
 
Hi Rehabman 10.11.6 ? Is there a problem? To install...
 
Status
Not open for further replies.
Copyright © 2010 - 2024 tonymacx86 LLC
Back
Top