Contribute
Register

Fw0 does not appear

Status
Not open for further replies.
Joined
May 14, 2013
Messages
2
Motherboard
Mountain Lion 10.8.3
CPU
Intel i7 3770K
Graphics
Zotac Gtx660 2GB
Mac
  1. MacBook Pro
Classic Mac
Mobile Phone
  1. iOS
Hello all,

I have installed my OSX in my PC successfully, but I have a problem. When I run IFCONFIG it only appears the following:

lo0: flags=8049<UP,LOOPBACK,RUNNING,MULTICAST> mtu 16384
options=3<RXCSUM,TXCSUM>
inet6 fe80::1%lo0 prefixlen 64 scopeid 0x1
inet 127.0.0.1 netmask 0xff000000
inet6 ::1 prefixlen 128
gif0: flags=8010<POINTOPOINT,MULTICAST> mtu 1280
stf0: flags=0<> mtu 1280
en0: flags=8863<UP,BROADCAST,SMART,RUNNING,SIMPLEX,MULTICAST> mtu 1500
options=2b<RXCSUM,TXCSUM,VLAN_HWTAGGING,TSO4>
ether bc:5f:f4:4a:c8:cb
inet6 fe80::be5f:f4ff:fe4a:c8cb%en0 prefixlen 64 scopeid 0x4
inet 192.168.2.4 netmask 0xffffff00 broadcast 192.168.2.255
media: autoselect (100baseTX <full-duplex,flow-control>)
status: active

I have plugged a firewire card with a RME FireFace 400 and it is working, but FW0 device does not appear. I want it to appear because sometimes the audio card does not boot properly (host led remains in red) and I have to manually turn off and on the card to make it work so I was thinking about program

ifconfig fw0 down
ifconfig fw0 up

with automator during each booting in order to "fix" the problem..


Any idea?
Thanks in advance!

Mario.
 
Joined
May 14, 2013
Messages
2
Motherboard
Mountain Lion 10.8.3
CPU
Intel i7 3770K
Graphics
Zotac Gtx660 2GB
Mac
  1. MacBook Pro
Classic Mac
Mobile Phone
  1. iOS
Finally I have been able to fix the problem. The matter was in the Firewire card's position. I have change the position and now it works perfectly. I attach a pic for anyone with the same problem!

Regards.

firewire.jpg
 
Joined
Feb 3, 2011
Messages
1,357
Motherboard
Gigabyte Z390 AORUS Ultra
CPU
i9-9900K
Graphics
RX 590
if u have a extreme4/6 would u post a guide for the new users thx i dont need one
 
Status
Not open for further replies.
Top