- Joined
- Nov 25, 2010
- Messages
- 1,211
- Motherboard
- AsRock X570M Pro4
- CPU
- Ryzen 3700x
- Graphics
- RX 580
Hi Kiwi, you're question is the most challenging of the entire build. I think (based on my experience) that since your Praeton cooler fins are 29mm high, I'd cut your I/O shield hole similar to my first & second cubes. You likely already realize that the closer the hole is cut to the latching mechanism, the greater your risk of the cooler not fitting.
For fitment of you four mounting posts, make sure the motherboard ports are directly against the inner surface of the cube I/O.
Cut your hole small at first, so you can determine whether you need to file higher or lower to fit the shield and motherboard with cooler attached.
Good Luck!
Ersterhernd
For fitment of you four mounting posts, make sure the motherboard ports are directly against the inner surface of the cube I/O.
Cut your hole small at first, so you can determine whether you need to file higher or lower to fit the shield and motherboard with cooler attached.
Good Luck!
Ersterhernd