I am looking for some advice regarding how to go about setting up my HDMI audio with my Intel HD4600.
I have the following logic board and CPU,
Asus Z97 deluxe 3.1
intel i7 4790k
I am running Yosemite 10.10.4, and for the most part have everything working using clover, and a couple KEXTs installed from multibeast.
I used this to get audio working with my ALC1150 codec:
https://github.com/toleda/audio_CloverALC
The last thing i need to get working is the HDMI audio. it is not showing up as a sound device. The reason for posting is that there are a lot of guides from Toleda, and i do not want to go though a lot of trial and error just to mess everything up. I would really appreciate a push in the right direction in terms of the exact guide to follow steps to take. I would like to keep as much working in clover as possible. I do not think that I will be adding a GPU to my system later. If i do, It would probably be a Quadro card as I do not to so much gaming. So i do not think that i am very worried about making sure that i can also get HDMI audio out of a GPU in the future.
I have attached my current .config and SSDT.aml files.
i also have the following KEXT and .efi drivers installed on my EFI partition
/clover/kexts/10.10/AppleIntelE1000e.kext
/clover/kexts/10.10/FakeSMC.kext
/clover/kexts/10.10/realtekALC.kext
/clover/drivers64UEFI/FSInject-64.efi
/clover/drivers64UEFI/HFSPlus.efi
/clover/drivers64UEFI/OsxAptioFixDrv-64.efi
/clover/drivers64UEFI/OsxFatBinaryDrv-64.efi
/clover/drivers64UEFI/NTFS.efi (this did not do what i though it was going to do and I think i will remove it.)
Please let me know if there is any additional info I should provide.
Thanks!