Search results

AMD R9 Fury X works fine

The same thing happens to me. Mojave crashes on the first attempt, then boots properly, the second time. I found that if you open the bios, then save it without making any changes, my system doesn't crash.

Check your AVX offset setting in the bios

My iMessage stopped working after I installed Mojave. I tried the solutions provided here to no avail. I finally booted my Hackintosh drive with my real mac laptop. iMessage worked when running on the real Mac. I then put the drive back in my Hack and iMessage has continued to work properly...

Should be a clear CMOS jumper on the motherboard. Turn off the system, unplug it and short the jumper

This is what I use in the custom flags section of Clover Configurator. Might work for you. uia_exclude=HS03;HS09;HS10;HS11;HS12;HS13;HS14;SS01;SS02;SS03;SS04;SS05;SS07;SS08;SS09;SS10;USR1;USR2

Make sure you have the bios in the advanced mode. The AVX offset will be under CPU configuration

Check your AVX offset setting. should be zero or auto

You need to ensure the thunderbolt card is in the proper slot. You also have to boot into Windows at least once to install the Windows drivers and activate the card. OSX will not show thunderbolt available unless you have a thunderbolt device plugged in and running before you boot.

I used ioreg to determine which usb ports to disable. I added this to my config.sys in the boot section using Clover Config uia_exclude=HS03;HS09;HS10;HS11;HS12;HS13;HS14;SS01;SS02;SS03;SS04;SS05;SS07;SS08;SS09;SS10;USR1;USR2 Sleep now works

I have an Asrock Taichi Z370. The Thunderbolt card has to be installed in PCIE slot 5. I boot with OsxAptioFix2Drv-free2000.efi I have the top of usable lower Dram set to 1gb in the bios. My Thunderbolt card seems to work normally. The Thunderbolt Display camera, Ethernet, and Firewire all...

I had the same problem with my Asrock Taichi. It was the AVX offset in the BIOS. Change this to 0 or whatever the lowest setting is.

Sorry, I misspoke. Change the Top of usable RAM to 1GB

Try changing the Top of lower usable RAM from dynamic to 1TB and use OsxAptioFix2Drv-2000.efi Make sure the TB3 card is in the correct slot on the motherboard

Thanks, I'll work on this next week

I have sleep working now. when it wakes up, I get a USB device disabled too much power error. All my USB devices appear to be working though.

In this case why not a real Mac laptop?

Update went smoothly. Fury X recognized as AMD R9 xxx 4096 mb. No need for Lilu, Shiki, WhateverGreen, or RadeonDeInit. Thunderbolt display works via Thunderbolt output from Asrock Thunderbolt 3 AIC. Display camera, sound, firewire and USB hub all work via Thunderbolt connection.

Fury X working with 10.13.4 release. Does not need Lilu, Shiki, WhateverGreen, or RadeonDeInit. Fury X is recognized as AMD R9 xxx 4096 MB.

Update. I now have the Thunderbolt display camera and USB Hub working. I had to install the Thunderbolt AIC into PCIE slot 5. I also had to set the Top of Lower Usable Dram to 1GB in the BIOS. The only Aptio memory fix that would work with the 1GB setting was OsxAptioFix2Drv-Free2000.efi