Recent content by wmelnick

Really? That blows :( Is this a Mac-specific problem? The card came with a crossfire cable, so I have to assume it is not a limitation of the hardware.

I do not care about it being one card. Two is perfectly fine, I just want to know if another 5770 is all I need or if I need to get 2 completely different cards.

That is for sandy bridge built-in graphics with an additional video card according to the specs. My machine, as you can see in my sig, is an i7-950, which is pre-sandy bridge. It also is 4 monitors, not 6.

I have seen posts about running 6 monitors (3 x 2) in SL, but none in Lion. I am about to take on a massive project that will require me to be monitoring a large number of servers while writing and testing code. I prefer to do all of this off of a single machine with a lot of monitors rather...

I just bought the new MacBook Air 15" which seems to be damned close to this machine. The About The Mac info shows this: Intel HD Graphics 3000: Chipset Model: Intel HD Graphics 3000 Type: GPU Bus: Built-In VRAM (Total): 384 MB Vendor: Intel (0x8086) Device ID: 0x0116 Revision...

My H70 just arrived. Can't wait to put it in this weekend!

Are you using the ATI Experimental boot version of chameleon - A new version was released today in the new Multibeast? Also the right (Vervet) version of the driver? What are the choices you are shown in monitor - only 800x600? I am running a Sapphire HD5770 under 10.6.6 with 3 monitors...

I am looking to add 12GB to my GA-X58-USB2 motherboard. I am perfectly happy to remove what I have on it already. My question is what is the best deal I can get for 3 triple-bank 4GB DIMMs? I have heard that certain RAM, especially G.Skill does not work with this board. Also, am I better off...

I am running that motherboard and had 2 problems: (1) The network chip is slow under OS/X. I bought an inexpensive Intel GB LAN card and it works great. (2) ALC892 audio: For now the best solution if you want analog out is to patch your DSDT according to this thread: viewtopic.php?f=16&t=7536...

I just did this on a GA-X58-USB3 board and it works perfectly, so if you just need stereo for now, this works.

Tried that kext several times. It does not work on my motherboard. It shows strange characters for the names of the channels and gives no sound. Edit: Tried it again. The Info.plist shipped with that stop it from loading. Substituting in my own allows me to see my rear line out (Green) in...

I have edited the Info.plist on VoodooHDA 2.72 so that my rear green line out on the GA-X58-USB3 motherboard's ALC892 shows up in the prefPane (nid 20) with the controls active that I would expect, however it does not show up as an output option in the Sound panel. Is there a way to edit the...