Recent content by ndavidson

Its funny scrolling through the ICNS files and seeing G4 and G5 icons on an operating system that does not support those processors LOL

Great Build. I would do that with my Mac Plus but it was my first Mac and believe it or not it still works LOL

The first Mac i owned was a Mac Plus, then a Classic, Then an LC475, Then a Performa 2400, Then a PowerMac G4 which I still own and works flawlessly.

Acer 24" LED

Most of us have had the best luck with Gigabyte boards

OS X 10.7 Success. It was easier then installing 10.6.7 :headbang:

Ok here is what I did in a nutshell. Installed OSX 10.6.7. Used the DSDT for my board. Extracted the Mach Kernel and smbios.plist fron the iDisk image. installed Chimera 1.5.4 Installed driver kexts deleted org.chameleon.Boot.plist (32bit one) replaced it with org.chameleon.Boot.plist (64bit...

I pretty well did everything you did in your tutorial but when I tried to copy the kernel from the iBoot image to my hard drive it would not copy. I used some of what you said with some of tonymac said in his tutorial. I have to go back over my steps to figure out exactly what I did but I will...

Finally after alot of trial and error :banghead: I have a fully working Hackintosh. Hardware specs: i3 2100, Gigabyte P67A-D3-B3, Sapphire Radeon HD 5670, 8 GB G-Skill Ripjaws X DDRIII 1300, Seagate 500 GB Sata II, Generic FW-400 PCI Card, Cooler Master Hyper 101i CPU Cooler, Cooler Master...