Recent content by ilcaccillo

I've only seen your message now. After our last messages I followed the instructions in this link: https://www.tonymacx86.com/threads/success-gigabyte-designare-z390-thunderbolt-3-i7-9700k-amd-rx-580.316533/ And changed the config.plist as their instructions, and tried it again, the...

What other diagnostic information could I do or test? Let me know and I will do it, at the moment I only have the photos of the verbose mode

I haven't enabled anything or any fix int DSDT in the config.plist, I don't even know what is "DSDT" or the "config.plist". My USB installation pen was just made in Unibeast, thats it, no changes made. I've just added the SSDT-EC.aml in /EFI/CLOVER/ACPI/patched because it was a solution for...

Thank you P1lgrim, I really appreciate your help, I know that all of this is pretty basic to you guys but I'm just an humble first timer. Thank you for understanding So I used EFI mounter to mount the UBS stick EFI partition and put SSDT-EC.aml in /EFI/CLOVER/ACPI/patched. I tried to install...

I've searched for it and none of the threads show the same problem I have. In most of threads the installation is stuck in the 1689 line. It's not my case, my installation has still 2 more lines after the 1689, one that says "load succeeded" and the last line is "root" So I'm not sure if my...

Thank you so much, so it means I can't use Unibeast with Clover and have to do another installation USB pen?

that is a guide to making an OpenCore based system, but it doesn't explain what OpenCore is. Could you please let me just know what is OpenCore?

Thanks for the link, it has a lot of information there I will read and go through it. Could you please let me just know what is OpenCore? I'm not familiar with the term and hackintosh procedures in general Thanks

Hello, I'm new to the Hackintosh world, so it's my first time trying to do this, I'm not experienced in the project and I've read the installation guide and I'm learning along the way. I was able to do an install USB pen of Catalina using Unibeast 10.3.0. I have a Gigabyte Z390 Designare...

I think the advice given was for you to disconnect (take the cable off) of the Windows drive when you install MacOs on the other drive, or vice-versa. I don't think you will have any problems with that. The problem seems to be during the installations or during Windows or MacOs updates