Since updating to monterey my monitors reset to their default scale and orientation after every reboot of macOS. Everything else appears to work normally. I have dual dell P2715Q monitors connected via displayport to rx580. The secondary monitor is located to the left side and is rotated 90º...
I don't believe that's the case for my board. I cannot set nvram variables and have them persisted after boot without using EmuVariableUefi.
Another question about your configuration. Does anyone else here have FileVault2 enabled? I'm wondering if this is related to using FileVault2 disk...
@ThrasherOSX thanks for the update. I just wanted to confirm everyone is experiencing the same thing I reported in https://www.tonymacx86.com/threads/unlock-with-apple-watch-not-working-in-catalina.287027/#post-2033342. I guess these are really the same issue threads and could likely be merged.
@scottkendall just to clarify your answer, after updating to 10.15.3 you reinstalled macOS 10.15.3 on top of the existing installation and that caused unlock with apple watch to start working again? Can you also confirm you had the same exact symptoms where all other handoff/continuity features...
@itwas not sure where you got that info. It's supported on Catalina.
Software Version: 8.10.64
Last Update: 2020-01-15
OS: macOS 10.15,macOS 10.14,macOS 10.13
File Size: 83 MB
I can confirm the same. 10.15.2 update did not fix. I even tried all of the normal troubleshooting steps over again just to be sure.
1. Unpaired my apple watch and repaired
2. Signed out of icloud on mac, restarted and signed back in
3. Restarted phone watch and mac
4. Toggled wifi and...