- Joined
- Feb 15, 2014
- Messages
- 16
- Motherboard
- Acer Aspire S3 - 391- V1.15
- CPU
- CPU i3- 2377m CPU 1.50GHz HM77 - S3-391
- Graphics
- Chip Set Graphics: Intel(R) HD Graphics 3000 Sandy Bridge Rev 9
- Mac
- Classic Mac
- Mobile Phone
I did install that Kext. However since that then I started with a fresh USB Key and worked the process from the start.
Happy to say I am moving forward ....
Here is a screen shot thus far on the new USB Key.
-V only at this point..
View attachment 121380
This is the info that should have been in my signature... I will get it set up..
Thank you for the help and pointers.
System:ACER / ASPIRE S3 - 391 (Chimera)
CPU: Intel i3-2377m CPU @ 1.50GHz + Intel Sandy Bridge Rev. 9
Graphics: Intel(R) HD3000, 1366x768
Thank you RehabMan, You were correct it is a HM77
I will work through the documents, and detail for a Mixed System.....I can't seem to figure out how this is completed..
Can I assume that I need to use your editor MaciASL to accomplish this... and edit the Info.plist file to include the two changes to support the HD3000
I am pulled down the zip files and they are in the same folder as MaciASL
Would that make sense?
Thanks again for the help on this ...
I did as you suggested, picked up an new usb key and then walked through Clover. Everything seemed to be straight forward, however I seem to have failed at the same spot in boot..
I used the file CLOVER/config_HD3000_1366x768_7series.plist.webloc (This is for a HD3000 77 Series Board - mixed system)
Here is a screen shot... Thanks again for all the help....
View attachment 121726