Hey,today I installed the new Mavericks on my Customac (Z77N-Board + all additional devices which were checked by TonyMacOsx86). With Mountain Lion I always needed to start with PCIRootUID=0 and GraphicsEnabler=no in the command-line until I installed Mountain Lion and did do the Multibeast and Chameleon Wizard adjustments. Then it was perfectly working without any help.With the Mavericks-installation I am a little surprised because I installed the whole system (I prepared with Unibeast 3.0) without putting anything in the command-line at the boot screen. But after I used the latest Multibeast-version and choosed Chimera 2.2.1 and the Chameleon style for it I cannot boot in the system again. I tried to reinstall Mavericks but it is not installing anymore. Instead of starting it is loading and then tries to start but only shows a white screen. Even in verbose-mode no errors and when the system starts, white screen only.Any ideas? Thanks a lot