pastrychef
Moderator
- Joined
- May 29, 2013
- Messages
- 19,458
- Motherboard
- Mac Studio - Mac13,1
- CPU
- M1 Max
- Graphics
- 32 Core
- Mac
- Classic Mac
- Mobile Phone
I updated to 0.7.4 but then my Windows 10 boot would not launch. I would either get a blank screen or a message from Windows saying "Preparing Automatic Repair" but nothing would happen. I'd have to hard reboot. Booting directly from BIOS menu to Windows worked fine.
I downgraded back to 0.7.3 and Windows boot again worked fine.
Comparing the 0.7.3 config.plist to 0.7.4 and trial and error I found that if I removed SSDT-DMAR.aml and the corresponding delete then the boot to Windows worked fine BUT when launching into MacOS networking did not work. No ethernet, wifi or bluetooth. I put DMAR back in and network works again but Windows boot broken again.
Back to 0.7.3 for now but any ideas why this is happening?
Thanks in advance.
If you remove SSDT-DMAR and the delete DMAR, you should enable config.plist > Kernel > DisableIoMapper.