- Joined
- Jul 23, 2012
- Messages
- 536
- Motherboard
- Asus Prime X570 Pro
- CPU
- Ryzen 9 3900X
- Graphics
- RX 590
- Mac
- Mobile Phone
Is there any way to download Hackintool v1.8.2 again?
Hi @headkaze )
The new guidelines for USB (since hackintool1.9.4) do not specify anymore that renames (EHC1->EH01 and EHC2->EH02) should be reverted (or disabled) at the end of the procedure.
Is this a mistake (renames should be disabled))?
Or is this right (renames should be maintained)?
Thanks,
-a-
My hardware is Z97-A and has both ehc1 and ehc2.The hardware in your profile has no EHCI controller at all. Therefore EHCx->EH0x renames are not applicable anyway.
If your hardware did have an EHCI controller (7, 8, 9-series chipset), the renames must be kept for as it is required by USBInjectAll.kext. If you're not using USBInjectAll.kext, then your ACPI names for the ECHI controller (if you had hardware with one), must match the names as coded in the Info.plist of your port injector kext.
Donejust add these:
That's obviously not right but you're also using an old version of Hackintool. Please use the "Check for Updates..." menu.At some point when I plug the USB3.0 device everywhere (maybe when I plug it into the USB-C port, not sure) I get the following:
Happy to hear you like the utility. I made a post here if you want to pin it.Might be worth creating a new thread for the MountEFI utility in Forums/General Help and making it a sticky which you can use as a place to download the latest version from, change log ... etc.
Previous versions of hackintool said to remove the renames after deleting usbinjectall. Current version doesn't. Hence my question.
Thank youDepends on how your USB injector kext is coded.
Are there multiple ways to perform renames?
There are 2 ports , USR1 and USR2 on my laptop.
What are they for ? Should I disable them ?