I created an install USB with Unibeast using standard settings for UEFI boot > Format USB Stick to Mac OS Extended (Journaled) using GUID Partition Map and named USB > Selected UEFI Boot Mode > Do not select any of the Graphics injection options > Create the Install Stick. After Install I went to the newly created EFI partition and edited the config.plist to replace iMac14,2 with iMac18,1 which is the closest real Mac to the hardware in the Brix - it uses Intel Graphics
Hello
@the_gael, thank you once more.
Following your suggestions I've been able to install macOS Mojave on my GB-BKi3HA-7100, dual boot with Windows 10 on separate drives. The steps / configurations that worked for me are:
BIOS:
1. Load optimised defaults.
2. Enabled CSM Support.
3. Disabled VT-d.
I didn't need to set the storage to Legacy.
Install:
1. Formatted the macOS install USB to Mac OS Extended (Journaled) with GUID Partition Map (I was missing this setting the first time I tried).
2. Used UniBeast with default settings (UEFI) and no graphic options.
3. Created the Windows 10 USB using Rufus with Windows 10 official ISO and MBR as partition type.
4. I installed Windows 10 first on SSD (M.2), then I installed macOS on SSD (S-ATA). Then I set macOS SSD (S-ATA) with Clover as first boot option.
5. Using Multibeast as post-installation tool I had no success. I am sure to have checked the right options but it didn't work for me. So I manually updated my config.plist to replace iMac14,2 with iMac18,1 as you suggested, then I installed the kexts I needed to make the hardware work.
So far I have:
- Working ethernet and USB ports.
- Working graphics with Intel 620, but in 1440p instead of 4K. I have a LG 4K monitor — working smoothly elsewhere — connected using HDMI 2.0.
- Partially working audio. It works via HDMI only (and in rare occasions). My front AUX in port does not work at all with headphones or speakers.
- Not working Wi-Fi / bluetooth. I'm aware that Intel Wi-Fi chips can't work on a hackintosh.
Did you have the same problem I had with Multibeast?
Could you help me to troubleshoot my audio / video problems if you had similar issues, please?
I don't know if copy-pasting your config.plist would work in my configuration. If yes, do I need to install the additional kexts you used too? The only difference, as far as I can see reading the thread, is the Wi-Fi chip you replaced. I don't need it to be working since I'm using ethernet-only.
Thank you very much, I've been able to install a(n almost) perfect hackintosh on my Brix with your help!