Native ACPI files from Clover F4 are in CLOVER/ACPI/origin.
They are too old. Read "Problem Reporting" again. Carefully.
I have filled my memory details in SMBIOS.
Your settings there are likely incorrect.
My understanding: With SlotCount=2, you must have two entries in Modules.
And you should verify the number of slots with physical inspection.
If you actually have two slots, it is probably worthwhile swapping the location of the single RAM stick.
Or installing two sticks for dual-channel support.
Also my DVMT is set to 96MB. So no patching required.
You should try DVMT-prealloc 64mb. And keep in mind each time you change DVMT-prealloc (or any other BIOS option), you *must* re-extract/re-patch ACPI.
Also, try OsxAptioFixDrv-64.efi instead of OsxAptioFix2Drv-64.efi.
Also, InjectKexts should be "Detect". You have InjectKexts=true, but no kexts in Clover/kexts, which is a bit of nonsense. InjectKexts=Detect and placing "essential" kexts in Clover/kexts/Other will enable you do boot the installer and recovery partitions, but will not inject when booting your main install (as FakeSMC.kext is installed there).
Other:
- IGPU PM not implemented
- USB not implemented correctly
- USB WiFi not recommended
- best to remove unneeded software such as VirtualBox
Finally, you didn't answer my question in post #24... "Does it always crash?"