- Joined
- Nov 20, 2012
- Messages
- 166
- Motherboard
- Asus Maximus Viii Gene
- CPU
- Intel i7 6700k
- Graphics
- Evga 980Ti Classified
- Mac
- Classic Mac
- Mobile Phone
Showing some flaws on my work log. I drilled holes for the fans but used a drill gun instead of using a workstation from Dremel. I made too many mistakes on the hole drilling. but again, it will not show because of the filters also that I will put.
and the ghetto front fan bracket I made attached with lower part of my old front fan bracket from Laser Hive. All parts will be black except the outer case.
I also tested the revised back plate and motherboard tray.
I drilled another hole on the back plate to make the PSU fan facing up. and my usual orientation (back plate attached inside of the case)
and the ghetto front fan bracket I made attached with lower part of my old front fan bracket from Laser Hive. All parts will be black except the outer case.
I also tested the revised back plate and motherboard tray.
I drilled another hole on the back plate to make the PSU fan facing up. and my usual orientation (back plate attached inside of the case)