- Joined
- Jul 30, 2021
- Messages
- 7
- Motherboard
- MSI Z590i UNIFY
- CPU
- 10700K
- Graphics
- 5600XT
I've gone through the task of getting 11.2.3 installed on my configuration, building a USB map using Hackintool, and then using the resulting kext (removing USBInjectAll, etc.) to then update to 11.5.1. I can boot into the OS fine however I'm finding that devices connected to certain USB ports do not work even though they're detected according to Hackintool.
For example, I connect my keyboard to one port that was flagged as USB 3, 480 Mbps, they keyboard works fine. If I plug it into one of the ports that was detected as USB3, 5 Gbps, it does not.
How I discovered this is my wired keyboard is plugged into my monitor, which is plugged into the USB 3, 5Gbps port (SS08). That port shows 2-Port USB 3.1 Hub in Hackintool while the monitor is plugged into it. If I move the monitor's USB cable over to the port that was flagged as USB 3, 480 (HS10), the hub is detected and the keyboard works (and the hub is called 3-Port USB 2.1 Hub)
My board is an MSI Z590i Unify. I'm using OpenCore 0.7.1, Big Sur 11.5.1.
I'm struggling to understand the nuance here that is preventing some ports from functioning. In my System Information under USB, it shows USB 3.1 Bus and USB32Bus (where all the devices are currently showing) no matter how I plug things into it. Any ideas on what I've done incorrectly?
For example, I connect my keyboard to one port that was flagged as USB 3, 480 Mbps, they keyboard works fine. If I plug it into one of the ports that was detected as USB3, 5 Gbps, it does not.
How I discovered this is my wired keyboard is plugged into my monitor, which is plugged into the USB 3, 5Gbps port (SS08). That port shows 2-Port USB 3.1 Hub in Hackintool while the monitor is plugged into it. If I move the monitor's USB cable over to the port that was flagged as USB 3, 480 (HS10), the hub is detected and the keyboard works (and the hub is called 3-Port USB 2.1 Hub)
My board is an MSI Z590i Unify. I'm using OpenCore 0.7.1, Big Sur 11.5.1.
I'm struggling to understand the nuance here that is preventing some ports from functioning. In my System Information under USB, it shows USB 3.1 Bus and USB32Bus (where all the devices are currently showing) no matter how I plug things into it. Any ideas on what I've done incorrectly?