- Joined
- Feb 23, 2013
- Messages
- 11
- Motherboard
- Dual W8/OSx
- CPU
- i5 3570
- Graphics
- gforce GTX 650
- Mac
- Classic Mac
- Mobile Phone
Hello Everyone.
I screwed things up a little and am having trouble fixing it. I purchased a new case and installed everything in it, rebooted worked great except usb 3.0 was not working. So I reviewed a few posts went in and made a change to MB to add 3.0 support with out really doing too much research. I added the CalDigit line to the system and after this, I can not get the system to reboot.
I have tried all the different modes to boot and nothing is working. I tried -s to edit no keyboard. I can get the system to boot till it gets to a gret screen with the cursor in the top right under a normal boot but thats it.
My question is I know that MB added the following two ktext entries and if I remove them I would assume that she should boot back up again. But I can't seem to figure out how to di this from the boot screen. The two KT it added were CalDigitFastIO.ktext and CalDigitUSBxHCI.ktest
How can I remove these to get my machine back up and running again.
if it helps I am running Z77-Ds3h, i5 3570, but this is more of a edit problem than hardware, and my stupid mistake
Thanks for your help.
I screwed things up a little and am having trouble fixing it. I purchased a new case and installed everything in it, rebooted worked great except usb 3.0 was not working. So I reviewed a few posts went in and made a change to MB to add 3.0 support with out really doing too much research. I added the CalDigit line to the system and after this, I can not get the system to reboot.
I have tried all the different modes to boot and nothing is working. I tried -s to edit no keyboard. I can get the system to boot till it gets to a gret screen with the cursor in the top right under a normal boot but thats it.
My question is I know that MB added the following two ktext entries and if I remove them I would assume that she should boot back up again. But I can't seem to figure out how to di this from the boot screen. The two KT it added were CalDigitFastIO.ktext and CalDigitUSBxHCI.ktest
How can I remove these to get my machine back up and running again.
if it helps I am running Z77-Ds3h, i5 3570, but this is more of a edit problem than hardware, and my stupid mistake
Thanks for your help.