- Joined
- Jul 28, 2013
- Messages
- 16
- Motherboard
- INTEL
- CPU
- 2,99 GHz Quad-Core Intel Core i5
- Graphics
- Radeon RX 580 4 GB
your welcome these flags should get u in if u dont want to go the chameleon wizard route -v cpus=1 dart=0 npci=0x2000
Hi Stehor, great post.
I unfortunately came across your post too late
So I would only ask you few things... (before I start a complete new installation of Maverick due to "bad" multi beast and Chameloen wizard settings)
Could you be so kind to see my post here:
http://www.tonymacx86.com/general-h...way-avoid-complete-maverick-installation.html
So…I will be grateful to get a reply …THX
EDIT: Just to note that I am using an SSD disk so in multi beast I checked the TRIM enabler (good/bad?)
...And asking about a confusing npci 2000 or 3000 usage, on the screenshots you have checked the 3000 option, but in your post you are saying to use 2000.
Second thing…you have two kexts attached, when should I use them? Before or after multi beast installation? and if I need them anyway (in which scenario)?
Do I need to uncheck (not use) the CPU management kext from Multibeast in the case that I use the one you have attached?