- Joined
- Jul 20, 2012
- Messages
- 2
- Motherboard
- << need manufacturer name and model # >> See Forum Rules !!
- CPU
- i7-2600K
- Graphics
- << need model # >> See Forum Rules !!
Trying to install on GA-Z68-UD3H-B3 F11 using legacy mode.
I get to the "post installation" phase, and end up in an install loop. El Capitan is installed but after
restart, the clover USB bootloader does not see the disk with El Capitan on it. If I choose the usb boot again
it just starts to install over again.
I've been running LION and SNOW LEOPARD for quite a while without problems on this machine.
I'm not trying to upgrade, but installing on a clean disk.
Any ideas ?
Thanks.
-rick
I get to the "post installation" phase, and end up in an install loop. El Capitan is installed but after
restart, the clover USB bootloader does not see the disk with El Capitan on it. If I choose the usb boot again
it just starts to install over again.
I've been running LION and SNOW LEOPARD for quite a while without problems on this machine.
I'm not trying to upgrade, but installing on a clean disk.
Any ideas ?
Thanks.
-rick