- Joined
- May 29, 2012
- Messages
- 8
- Motherboard
- Hackintosh
- CPU
- i3770
- Graphics
- HD 6870
- Mac
- Classic Mac
- Mobile Phone
Hi everyone.
I'm going crazy trying to find out who to believe about enabling or not enabling TRIM on the vertex 3 with sandforce controller...I've been using the drive for a week now witouth enabling trim and everything is super fast. what should i do? I dont want my computer to slow down over time or ruin the ssd.
Some say TRIM is no needed because the Vertex 3 uses sandforce controller and manages GC on its own. Others differ and suggest enabling TRIM even for ssd with sandforce controller.
I'm running Lion 10.7.4 on a GA-Z68XP-UD3 mobo, i7-2700k CPU, 32GB RAM...I think my sandforce firmware is 2.15 but i'm not sure and I can't check right now since I'm at work on my macbook but I'll post that later.
I really hope to find one definite answer for this...the quest begins LOL
I'm going crazy trying to find out who to believe about enabling or not enabling TRIM on the vertex 3 with sandforce controller...I've been using the drive for a week now witouth enabling trim and everything is super fast. what should i do? I dont want my computer to slow down over time or ruin the ssd.
Some say TRIM is no needed because the Vertex 3 uses sandforce controller and manages GC on its own. Others differ and suggest enabling TRIM even for ssd with sandforce controller.
I'm running Lion 10.7.4 on a GA-Z68XP-UD3 mobo, i7-2700k CPU, 32GB RAM...I think my sandforce firmware is 2.15 but i'm not sure and I can't check right now since I'm at work on my macbook but I'll post that later.
I really hope to find one definite answer for this...the quest begins LOL