Sorry for the Question.
I have a Asus Ex3 TB3 Card.
Its possible to install it on a Motherboard without TB3 Header like the Gigabyte Alpine or Titan Ridge?
Hello everyone, hope someone can help me. I've been stuck at this for more than 4 hours, I can't get Thunderbolt to work, it says drivers are not loaded. The TB3 ports are detected in the PCI, but it doesn't show up in the TB tab. I've attached the files that are in my EFI partition in my main drive. What should I be doing for this to work? I'm using clover configurator 2.4k r4700. thanks
It is my understanding that you will need to shut down the computer, remove the power cable and wait for around 15 seconds for the power to drain, connect and turn on Thunderbolt device, then plug in and turn on computer.
Also, I'd suggest using the SSDT on the other thread for full TB Node instead of flashing the EX3.
I had a Alpine Ridge with flashed ROM. I connect pin 3 and 5 so no header/cable to Z490 Vision D.
TB3 works perfectly with hot plug. However, I can't get USB work.
I see USB controller info in System Information - PCI but can't use USBC card reader or any USBC device.
it has something to do with the SSDT you are using I had the USB working the alpine ridge.
I really was only doing some testing you could try the SSDT on the first post I think the USB was working.Thank you for the info. I use RP21 for Alpine Ridge SSDT and I do have one USB SSDT for onboard USB.
Could you take a look of my SSDT?
I really was only doing some testing you could try the SSDT on the first post I think the USB was working.
I tried it, doesn't work.