- Joined
- Aug 5, 2020
- Messages
- 38
- Motherboard
- Gigabyte Z490 Vision G
- CPU
- Intel i5 10400
- Graphics
- Gigabyte Radeon RX580 8Gb
Successfully deployed my first Hackintosh thanks to CaseySJ's Gigabyte Z490 Vision D build!
Gigabyte Z490 Vision G
Intel i5 10400
Gigabyte Radeon RX580 8Gb
Samsung 970 EVO Plus 1Tb M.2
32Gb Ram (Corsair Vengeance 2x 16GB RAM DDR4, 3200MHz)
Had trouble with my initial Clover install then stumbled CaseySJ's (very similar) build so figured I'd try following his brilliant instructions - BOOM!!! I stuck to the steps verbatim and it installed and booted first time and took less than an hour! Brilliant write-up, step-by-step instructions and attached file sets! Thank you CaseySJ!
The ONLY 2 small changes to the step-by-step instructions I'd suggest are to do with the "Vision G" - specific part.
(1) Suggest a spoiler link for the "Vision G" peeps before end of Step 4 (ie: during OpenCore Configurator and before Copy EFI folder to EFI partition) to the Vision G section.
(2) The name of the file in the G Package is “SSDT-UIAC-VISION-G-V2.aml” so I have used this file name in place for both the below steps:
G.
Gigabyte Z490 Vision G
Intel i5 10400
Gigabyte Radeon RX580 8Gb
Samsung 970 EVO Plus 1Tb M.2
32Gb Ram (Corsair Vengeance 2x 16GB RAM DDR4, 3200MHz)
Had trouble with my initial Clover install then stumbled CaseySJ's (very similar) build so figured I'd try following his brilliant instructions - BOOM!!! I stuck to the steps verbatim and it installed and booted first time and took less than an hour! Brilliant write-up, step-by-step instructions and attached file sets! Thank you CaseySJ!
The ONLY 2 small changes to the step-by-step instructions I'd suggest are to do with the "Vision G" - specific part.
(1) Suggest a spoiler link for the "Vision G" peeps before end of Step 4 (ie: during OpenCore Configurator and before Copy EFI folder to EFI partition) to the Vision G section.
(2) The name of the file in the G Package is “SSDT-UIAC-VISION-G-V2.aml” so I have used this file name in place for both the below steps:
- In the OpenCore ACPI folder, replace SSDT-UIAC-VISION-D-V2.aml with SSDT-UIAC-VISION-G-V1.aml located in the attached Vision G Package.zip
- Then open config.plist in OpenCore Configurator and change the rename SSDT-UIAC-VISION-D-V2.aml to SSDT-UIAC-VISION-G-V1.aml in the ACPI section.
G.
Last edited: