DSDT removed, reverted back to your HD300 7series 1366x768 config
Still same symptoms
If you can't boot, a bare minimum is:
- Boot verbose, attach photo
- Attach EFI/Clover folder as ZIP (press F2 then F4 at main Clover screen just before collecting). Please eliminate 'themes' directory. Provide only EFI/Clover, not the entire EFI folder.
DSDT removed, reverted back to your HD300 7series 1366x768 config
Still same symptoms
I'm not sure what else is required, I've attached the Clover Folder.
I can take a photo of a black screen but I can't see how that helps anything.
You never mentioned anything regarding black screen.
As per guide, you should try booting with an invalid FakeID (0x12345678).
You may need to inject EDID.
Apologies Rehabman, it was in Post 17.
With regards to EDID injection for an installer, are there any suitable guides or resources you could guide me to? I'm struggling to locate a guide that could help me. I've extracted the EDID information from booting Windows on the laptop (popped the old hard drive in to run Windows again.)
No need to inject EDID for the installer (although it is easily done in config.plist/Graphics/EDID).
You can use an invalid FakeID, and work on graphics (EDID inject, backlight control, etc) in post-install.
I have tried FakeID previously it's the same outcome sadly.
You will need to attach PR files that represent this attempt.
As requested, still black screen, system hang. No verbose