Oh boy, I heard sound. using PCLinuxOS
Try that and see.ok so i used 6,1 for system def, should i use imac14 or any other verison?
I am having the exact same problem. Very new here, learning curve is steep, but a lot of resources on this page.
I had the Hackintosh up and running within 24 hours of receiving the component parts, but was having problems with the NVidea drivers, so decided that I would do a clean install. Now I'm unable to boot from USB to get Unibeast going.
I went through this guide to get rid of my 15-20 boot priorities, back down to just one, the real hard drive.
https://www.tonymacx86.com/threads/...boot-entries-prevent-further-problems.175274/
Am very interested to see how this goes.
So when i tried to boot from usb via bios it says insert bootable drive and try again, so I used clover to boot from the usb and it hangs with just a little bit left on the progress bar.
I created a brand new bootable usb with unibeast and could not boot off it. I am assuming i will need to wipe the drive but assumed i would be able to do that once i got into the installer. Doesn't look like i can get to it.
I created a brand new bootable usb with unibeast and could not boot off it. I am assuming i will need to wipe the drive but assumed i would be able to do that once i got into the installer. Doesn't look like i can get to it
Before I could complete and post , you had figured out . goodSo what i had to do is boot into bios, change boot option priorities to the usb as #1. Then it finally clover came up with the installer and it ran from there.