- Joined
- Nov 8, 2010
- Messages
- 92
- Motherboard
- HP Elitebook 840 G6
- CPU
- i5-8365U
- Graphics
- UHD 620
Hi
I have Sierra 10.12.6 up and running and I am trying to install HS.
Config:
Gibagyte H67MA-USB3-B3 bios F8
CPU Intel(R) Core(TM) i5-3550 CPU @ 3.30GHz
Clover v2.4k r4297 in legacy mode on a SATA SanDisk SSD 120Gb
/dev/disk3 (internal, physical):
#: TYPE NAME SIZE IDENTIFIER
0: GUID_partition_scheme *120.0 GB disk3
1: EFI EFI 209.7 MB disk3s1
2: Apple_HFS Sierra 119.2 GB disk3s2
3: Apple_Boot Recovery HD 650.0 MB disk3s3
I have 2 other disk installed with W7 and W10
I have downloaded HS and have the full 5GB install file on /Applications
To avoid conversion to APFS, I ran the command "/Applications/Install mac OS High Sierra/Contents/Ressources/startosinstall --converttoapfs NO"
Just after this, it rebooted and when I select "macOS Install" from Clover it stop and I have no progression bar.
When I boot in verbose mode, first time it stops at :
HID : Legacy shim 2
SATA Warning Enable Drive PHY PM Failed
On a second attemp, it stops just after HID line above, the SATA line was not displayed.
So what's wrong with the SATA ?
My EFI folder content, config.plist and preboot.log and debug.log attached.
Thanks
I have Sierra 10.12.6 up and running and I am trying to install HS.
Config:
Gibagyte H67MA-USB3-B3 bios F8
CPU Intel(R) Core(TM) i5-3550 CPU @ 3.30GHz
Clover v2.4k r4297 in legacy mode on a SATA SanDisk SSD 120Gb
/dev/disk3 (internal, physical):
#: TYPE NAME SIZE IDENTIFIER
0: GUID_partition_scheme *120.0 GB disk3
1: EFI EFI 209.7 MB disk3s1
2: Apple_HFS Sierra 119.2 GB disk3s2
3: Apple_Boot Recovery HD 650.0 MB disk3s3
I have 2 other disk installed with W7 and W10
I have downloaded HS and have the full 5GB install file on /Applications
To avoid conversion to APFS, I ran the command "/Applications/Install mac OS High Sierra/Contents/Ressources/startosinstall --converttoapfs NO"
Just after this, it rebooted and when I select "macOS Install" from Clover it stop and I have no progression bar.
When I boot in verbose mode, first time it stops at :
HID : Legacy shim 2
SATA Warning Enable Drive PHY PM Failed
On a second attemp, it stops just after HID line above, the SATA line was not displayed.
So what's wrong with the SATA ?
My EFI folder content, config.plist and preboot.log and debug.log attached.
Thanks