- Joined
- Nov 26, 2014
- Messages
- 27
- Motherboard
- Gigabyte Z97X-UD3H
- CPU
- i7 4790k
- Graphics
- GeForce GT 740
- Mac
- Classic Mac
- Mobile Phone
Booting from a Clover USB: installed El Capitan over my previously functioning Chimera / Yosemite hard drive. BIOS remains unchanged from my previous successful install.
My El Capitan Install USB functions fine. However when booting from my OSX drive post-install, I encounter a reboot loop.
It appears to happen in pretty much the same place, regardless of my config: as pictured below. *NOTE* I have been entering the boot flags manually, so this is just the default Clover config I see after a fresh reboot.
I followed the Clover USB guide, copied FakeSMC.kext into both the 10.10 and 10.11 folders in the EFI partition. Tried various USB ports, as well as various combinations of cpus=1, -x, NVIDIA injection, checking off Generate C states and P states.
Gigabyte z97-ud3h-bk
i7-4790k
NVIDIA Geforce-740 GDDR5 Superclocked
24gb of Crucial memory
My El Capitan Install USB functions fine. However when booting from my OSX drive post-install, I encounter a reboot loop.
It appears to happen in pretty much the same place, regardless of my config: as pictured below. *NOTE* I have been entering the boot flags manually, so this is just the default Clover config I see after a fresh reboot.
I followed the Clover USB guide, copied FakeSMC.kext into both the 10.10 and 10.11 folders in the EFI partition. Tried various USB ports, as well as various combinations of cpus=1, -x, NVIDIA injection, checking off Generate C states and P states.
Gigabyte z97-ud3h-bk
i7-4790k
NVIDIA Geforce-740 GDDR5 Superclocked
24gb of Crucial memory