- Joined
- Jan 24, 2013
- Messages
- 16
- Motherboard
- Gigabyte GA-Z77-DS3H
- CPU
- i5-3570K
- Graphics
- GTX 660 Ti
Hello everyone,
It's not my first build, but I can't find any solution about what happens. The first steps are ok :
- making the Unibeast USB drive is ok ;
- Bios settings are as usual for that kind of motherboard (SATA selection mode => AHCI / xHCI Mode => Auto / XHCI Hand-off => Enabled / EHCI Hand-Off => Enabled) ;
- the boot from Unibeast USB drive is ok until the progress bar reaches its half. Then, several lines of text appear, and that state last a very few seconds, then the computer reboots.
The configuration is very minimalistic : just a power supply, one SSD, one 4 GB RAM, and no graphic card. I tried to connect the monitor on HDMi port and DVI Port : same result.
I tried the Unibeast USB key Drive on my current Hackintosh, the one on my signature, it works fine.
Any idea about what is happening ?
Thank you a lot for your help !
It's not my first build, but I can't find any solution about what happens. The first steps are ok :
- making the Unibeast USB drive is ok ;
- Bios settings are as usual for that kind of motherboard (SATA selection mode => AHCI / xHCI Mode => Auto / XHCI Hand-off => Enabled / EHCI Hand-Off => Enabled) ;
- the boot from Unibeast USB drive is ok until the progress bar reaches its half. Then, several lines of text appear, and that state last a very few seconds, then the computer reboots.
The configuration is very minimalistic : just a power supply, one SSD, one 4 GB RAM, and no graphic card. I tried to connect the monitor on HDMi port and DVI Port : same result.
I tried the Unibeast USB key Drive on my current Hackintosh, the one on my signature, it works fine.
Any idea about what is happening ?
Thank you a lot for your help !
Last edited: