Thank you!
So here is where I am... Kinda stuck.
I have been reading your advice and watching this vid..
http://www.youtube.com/watch?v=NftbLZi8-CE
At the time where in the video it is shown that there is an error and to not worry about it and reboot.. I didnt get an error?
I restarted and tried to do the 10.6.8 update and had an error..
My hack shows I am running 10.6.3?
I ran multi beast and I did not see any options for my motherboard? I ran everything else pretty much.
I got to where it wanted to install a network controller and I agreed and I beleive I have ran it twice now. It wanted a reboot... Somehow I think I had internet going before I ran the update? Safari opened??
I have never used a mac fyi. I do technical support on Windows...
I am running OSX off of a 16gb thumbdrive and its slowwww
So as of right now I cannot
1.Change the display settings to fill the screen only 1024x768 avail..
2.Boot without the iboot disc in drive I get a hit power button message
3.Cannot boot into windows using iboot? I think its because of the ACHI
4.I cannot see where it says under options in disk utility you "select MBR" (I erased my pre shrunk 100gb partition and formatted journaled
5. Do I have to turn ACHI mode off to run Windows?
Right now there is one physical actual Hard Drive (thumb drive is in usb slot too) my actual HDD is 500GB. 400 for win7 100 for osx
The ultimate goal is to put SnowLeopard on the 100gb and keep win7 on the 400.
Does multi beast actually install onto the mac HDD?
I am using a bootable win7 USB external drive w. Norton Ghost 11 to do my cloning... I will look into it further
Thanks again!!!!!