- Joined
- Mar 20, 2012
- Messages
- 43
- Motherboard
- Gigabyte GA-Z68X-UD4
- CPU
- i7 2600K
- Graphics
- Gigabyte GeForce GTX 1080 Gaming 8GB
- Mac
- Mobile Phone
Hey,
so first: from one day to another, my Sierra SDD wasn't able to boot.. It automatically turned off at the end of booting bar and in verbose mode it shows these commands in the last second before shutting down immediately:
another try:
i unplugged everything beside the keyboard and also tried booting without ANY USB-Devices attached - same problem.
So then i thought: okay, since my booting time increased a lot when i changed from chimera to clover somehow. i might as well try to install a fresh setup of High Sierra on another drive. But:
(Of course i set up the BIOS accordingly: Nothing but the graphics card (1080) in PCI, Optimized Defaults - AHCI, no VT-D, no USB 3.0..)
I can install High Sierra (BIOS/ Legacy Boot Loader) without a problem, but when it automatically restarts and i boot into the Bootloader of USB - i can't see my new installed System. I used a spare 1TB Hitachi HDD (formatted freshly GUID Partitio Table) - i tried 2 different USB Sticks for the Bootstick. Nothing... I will now try to use another hard drive, but i still dont get it.
Can anybody help me booting into my old Sierra or getting High Sierra to run / show the installed HDD ?!
Any idea ?
Any help is greatly appreciated.
so first: from one day to another, my Sierra SDD wasn't able to boot.. It automatically turned off at the end of booting bar and in verbose mode it shows these commands in the last second before shutting down immediately:
another try:
i unplugged everything beside the keyboard and also tried booting without ANY USB-Devices attached - same problem.
So then i thought: okay, since my booting time increased a lot when i changed from chimera to clover somehow. i might as well try to install a fresh setup of High Sierra on another drive. But:
(Of course i set up the BIOS accordingly: Nothing but the graphics card (1080) in PCI, Optimized Defaults - AHCI, no VT-D, no USB 3.0..)
I can install High Sierra (BIOS/ Legacy Boot Loader) without a problem, but when it automatically restarts and i boot into the Bootloader of USB - i can't see my new installed System. I used a spare 1TB Hitachi HDD (formatted freshly GUID Partitio Table) - i tried 2 different USB Sticks for the Bootstick. Nothing... I will now try to use another hard drive, but i still dont get it.
Can anybody help me booting into my old Sierra or getting High Sierra to run / show the installed HDD ?!
Any idea ?
Any help is greatly appreciated.