- Joined
- Nov 28, 2013
- Messages
- 2
- Motherboard
- 10.9.5.
- CPU
- intel i7 4950k
- Graphics
- NvidiaGTX560
- Mac
- Classic Mac
- Mobile Phone
Hi guys
I am here from 2008,and i make a Hackintosh these years which works 'till now...nowadays things are changed and i am started as a total NOOB
Now i completed new (old) maschine with Sapphire Radeon 5770 which has DVI, HDMI and Display port out....
Basically everything works fine because i find right DSDT file, i have ML 10.8.5 installed but....and the goddess of fortune was with me at this moment and of course one friend from Zagreb who help me a lot with some advices THX to him a lot
When i boot normally i have a fine correct scaled resolution on main monitor (1920x1200) and it is fine but on Toshiba TV 50" (second monitor) connected on HDMI output in HDMI splitter i have a max resolution of 720p or a little bit more 1360x768...and it is recognized as TOSHIBA TV
On this HDMI splitter i have a 2 Toshiba TV's in two separate rooms...on PC installation everything works fine...
When i start with AtiConfig=Vervet i have a lot more resolutions higher than 1920x1080 on second monitor but it is recognised as VGA monitor and of cource card cannot start in this resolution and allow me to set max 1280x720....when i try to set 1920x1080 or higher it always returns me on first resolution....
If i start with AtiConfig=Baboon i see only a small part of second screen on both monitors and i cannot do nothing....
I install ML 10.8.5 with unibeast and postinstall with multibeast....
Mobo: Gigabyte GAX38 DQ6, Sapphire Radeon 5770, 8 GB DDR2
Any suggestion for this problem maybe?
THX in advance....
I am here from 2008,and i make a Hackintosh these years which works 'till now...nowadays things are changed and i am started as a total NOOB
Now i completed new (old) maschine with Sapphire Radeon 5770 which has DVI, HDMI and Display port out....
Basically everything works fine because i find right DSDT file, i have ML 10.8.5 installed but....and the goddess of fortune was with me at this moment
and of course one friend from Zagreb who help me a lot with some advices THX to him a lotWhen i boot normally i have a fine correct scaled resolution on main monitor (1920x1200) and it is fine but on Toshiba TV 50" (second monitor) connected on HDMI output in HDMI splitter i have a max resolution of 720p or a little bit more 1360x768...and it is recognized as TOSHIBA TV
On this HDMI splitter i have a 2 Toshiba TV's in two separate rooms...on PC installation everything works fine...
When i start with AtiConfig=Vervet i have a lot more resolutions higher than 1920x1080 on second monitor but it is recognised as VGA monitor and of cource card cannot start in this resolution and allow me to set max 1280x720....when i try to set 1920x1080 or higher it always returns me on first resolution....
If i start with AtiConfig=Baboon i see only a small part of second screen on both monitors
and i cannot do nothing....I install ML 10.8.5 with unibeast and postinstall with multibeast....
Mobo: Gigabyte GAX38 DQ6, Sapphire Radeon 5770, 8 GB DDR2
Any suggestion for this problem maybe?
THX in advance....