Sandy Bridge Benchmark/Performance Thread

[jpa]

Re: SandyBridge Benchmark/Performance Thread

Cinebench scores... (4.2Ghz)

OH god!

is card

http://www.newegg.com/Product/Product.aspx?Item=N82E16814150490&Tpk=5870

games works nice?? works 100%?

recomend this card?

thanks

 

[Yoga]

Re: SandyBridge Benchmark/Performance Thread

Cinebench scores... (4.2Ghz)

OH god!

is card

http://www.newegg.com/Product/Product.a ... 0&Tpk=5870

games works nice?? works 100%?

recomend this card?

thanks

That's the card, yes. Works 100%.

No games installed on here, work installation until LGA2011 Mac Pro's are released :¬)

 

[Gordo74]

Re: SandyBridge Benchmark/Performance Thread

Cinebench scores... (4.2Ghz)

OH god!

is card

http://www.newegg.com/Product/Product.aspx?Item=N82E16814150490&Tpk=5870

games works nice?? works 100%?

recomend this card?

thanks

This is mine:

http://www.newegg.com/Product/Product.a ... -_-Product

Works 100%, it is recommended.

 

[jpa]

Re: SandyBridge Benchmark/Performance Thread

thanks Yoga and Gordo74

I must make a decision to buy:

Options:
XFX HD-587X-ZNFV Radeon HD 5870 - Yoga
HIS IceQ X Turbo X H687QNX1G2M Radeon HD 6870 - Not test
XFX HD-687A-ZDBC Radeon HD 6870 - Not test

which is better?

thanks

 

[Gordo74]

Re: SandyBridge Benchmark/Performance Thread

They will all perform about the same.

 

[Yoga]

Had a pop at 4.8Ghz :¬)

Scores

- Geekbench: 14321
- Xbench: 557.15
- Cinebench (CPU): 9.28

System

- Mobo (BIOS): Asus P67 Sabertooth B3 Revision (1305)
- CPU: i7 2600K @ 4.8Ghz
- RAM: 16GB Corsair Dominator 1600Mhz 8-8-8-24-2T
- GFX: XFX 5870 1GB
- HDD: OCZ Vertex 2E 100GB
- Display: Apple Cinema 24" (DisplayPort)

System Info & Drivers

- DSDT: Yes
- OS X: 10.6.7
- Kernel: 10.7.3
- Architecture: 64 bit
- Bootloader: Chameleon r750
- Branch: Andy (based off kabyl & AnVAL)
- GFX: 10.6.6 Vanilla ATI

BIOS Settings

- Multiplier: 48
- Vcore: 1.42
- Vcore Mode: manual
- Load-Line Calibration: Extreme
- VRM Frequency: 350
- Phase Control: Extreme
- Load Line Calibration: Enabled
- Turbo: Disabled
- EIST: Disabled
- Speedstep: Disabled
- Spread Spectrum: Disabled

 

[jpa]

Had a pop at 4.8Ghz :¬)

Scores

- Geekbench: 14321
- Xbench: 557.15
- Cinebench (CPU): 9.28

System

- Mobo (BIOS): Asus P67 Sabertooth B3 Revision (1305)
- CPU: i7 2600K @ 4.8Ghz
- RAM: 16GB Corsair Dominator 1600Mhz 8-8-8-24-2T
- GFX: XFX 5870 1GB
- HDD: OCZ Vertex 2E 100GB
- Display: Apple Cinema 24" (DisplayPort)

System Info & Drivers

- DSDT: Yes
- OS X: 10.6.7
- Kernel: 10.7.3
- Architecture: 64 bit
- Bootloader: Chameleon r750
- Branch: Andy (based off kabyl & AnVAL)
- GFX: 10.6.6 Vanilla ATI

BIOS Settings

- Multiplier: 48
- Vcore: 1.42
- Vcore Mode: manual
- Load-Line Calibration: Extreme
- VRM Frequency: 350
- Phase Control: Extreme
- Load Line Calibration: Enabled
- Turbo: Disabled
- EIST: Disabled
- Speedstep: Disabled
- Spread Spectrum: Disabled

woow very nice

 

[CroHack]

Stable 4.6 system for 24/7

Scores

- Geekbench: 15189
- Xbench: 614 (without hard test)

System

- Mobo (BIOS): Gigabyte GA-P67-UD4-B3(F2)
- CPU: i7 2600K
- RAM: 8 Gb
- GFX: XFX 5770 1Gb
- HDD: WD BlackCaviar 1,5Tb
- Display: SyncMaster F2380

System Info & Drivers

- DSDT: Yes
- OS X: 10.6.7
- Kernel: Darwin 10.7.3
- Architecture: 64 bit
- Bootloader: Chameleon r750
- Branch: -
- GFX: -

BIOS Settings

- Multiplier: 32
- Vcore: 1.42
- Vcore Mode: auto
- Turbo: Enable 49/48/47/46
- EIST: disable
- Speedstep: disable



Attachments:
File comment: Geekbench
geek.png

 

[Yoga]

Nice scores. I wonder why my Cinebench CPU score is higher, but your XBench and Geekbench are higher...

You would think it would be consistent. There's definitely room for tweaking with these set-ups :¬)

... and on that note, I just ran Geekbench again (4.2Ghz (B)), and it was just under my original 4.4Ghz score. nearly 700 points higher than my last run at 4.2Ghz (A)...

 

[doof]

all bios seting default except achi, proc voltage boosted to 1.375, turbo multi 44
E/E fakesmc blockstorage realtek audio
S/L/E realtek 889
using dsdt from autopatcher
no nullcpupm or sleep enabler but sleep and shutdown work

Screen shot 2011-04-07 at 4.26.46 PM.pngScreen shot 2011-04-07 at 4.46.17 PM.png
Still tweaking the overclock, this is with 44 multi. I think I can get a stable 48 which should put me in the 16-17k range. 6870 cinebench score sucks. I hope it will improve with better drivers.