- Joined
- Mar 21, 2011
- Messages
- 801
- Motherboard
- GA-Z390-Aorus Pro
- CPU
- i7-9700K
- Graphics
- RX 590
first, thanks for the guide.
i am trying to rebrand a DW1502, 168c:002b, sub 0204:1028.
i have downloaded and run the tool, and executed the /r512 command.
eeprom_dump.rom was written to the folder where the .exe is located.
i downloaded the hex editor and found the subvendor id and subdevice id, and changed them (flipping the bytes) to subvendor 103c, subdevice 3041.
i then clicked Save in the hexeditor, this creates a file called eeprom_dump.rom.bak which is a backup of the original dump, and creates eeprom_dump.rom, which is the edited file.
i opened eeprom_dump.rom and verified that the editing was done properly.
then i executed the /w512 command. the program asked "write raw data?" i clicked yes, and got a success message.
however, i checked device manager and the sub info had not been changed.
how do i specify the filename that the /w512 command should write from?
thanks
ken
i am trying to rebrand a DW1502, 168c:002b, sub 0204:1028.
i have downloaded and run the tool, and executed the /r512 command.
eeprom_dump.rom was written to the folder where the .exe is located.
i downloaded the hex editor and found the subvendor id and subdevice id, and changed them (flipping the bytes) to subvendor 103c, subdevice 3041.
i then clicked Save in the hexeditor, this creates a file called eeprom_dump.rom.bak which is a backup of the original dump, and creates eeprom_dump.rom, which is the edited file.
i opened eeprom_dump.rom and verified that the editing was done properly.
then i executed the /w512 command. the program asked "write raw data?" i clicked yes, and got a success message.
however, i checked device manager and the sub info had not been changed.
how do i specify the filename that the /w512 command should write from?
thanks
ken