Please Help...Mavericks Boot Error After Installing Touch-Base Drivers

[esoterrick]

I am new to this community (so please forgive me if I submitted this post in the wrong forum). I have done tons of research on this site for my build, but unfortunately I wasn't prepared for this obstacle being that I am a noob. I have an Acer T272HL monitor that I would like to use with my hackintosh for an audio production rig using Logic Pro X. Is there anything special I need to do when I install new applications (being that this is a hackintosh)?

My System:
Ga-Z87x-ud5h
4770K
Bios F8 (it will not update to f9 due out dated bios message)
Internal Graphics
Crucial 16GB Ballistix Tactical Memory
1 Samsung 250GB SSD Drive
1 Seagate Berracuda 1TB Drive
I installed Mavericks using the new installation guide

This is the panic message I get:

 

[rkrysl]

Are you setting up to run D-Touch? I hope you get your setup working! I am looking at adding one of these monitors as well!