<< Solved >> No Clover Boot Screen got (Desperated)

[JeQu]

I've follow step by step this guide, I've created USB as UEFI following the instructions at installation guide. No problems with this.
At BIOS I made changes:
LOAD OPTIMIZED DEFAULT
XHCI MODE - Enabled
XCHI HAND-OFF - Enabled
VT-D - Disabled
Windows 8 Features - SET TO OTHER OS
BOOT SECURE MODE - Disabled

All BIOS configuration screenshots

Saved and exit BIOS and reboot from USB, (see attached image). Note: If I choose UEFI:USB nothing happens

never got clover boot screen.
I got the following message and reboot again:

boot0: GPT
boot0: test
boot0: test
boot0: done
boot1: /boot6

After second reboot, black screen and nothing happens.
I'm desperated

 

[UtterDisbelief]

I've follow step by step this guide, I've created USB as UEFI following the instructions at installation guide. No problems with this.
At BIOS I made changes:
LOAD OPTIMIZED DEFAULT
XHCI MODE - Enabled
XCHI HAND-OFF - Enabled
VT-D - Disabled
Windows 8 Features - SET TO OTHER OS
BOOT SECURE MODE - Disabled

All BIOS configuration screenshots
View attachment 451714
View attachment 451716
View attachment 451717
View attachment 451718
View attachment 451719
View attachment 451720
View attachment 451723
View attachment 451721
View attachment 451722

Saved and exit BIOS and reboot from USB, (see attached image). Note: If I choose UEFI:USB nothing happens
View attachment 451724

never got clover boot screen.
I got the following message and reboot again:

boot0: GPT
boot0: test
boot0: test
boot0: done
boot1: /boot6

After second reboot, black screen and nothing happens.
I'm desperated

Two big problems:

1) You should Disable the Serial port

2) For your motherboard you should use UEFI boot mode, not the one in the screengrab. Create your UniBeast installer drive as UEFI and ensure you partition the destination drive as GUID.

I would also Enable EHC Handoff too.

 

[JeQu]

Two big problems:

1) You should Disable the Serial port

2) For your motherboard you should use UEFI boot mode, not the one in the screengrab. Create your UniBeast installer drive as UEFI and ensure you partition the destination drive as GUID.

I would also Enable EHC Handoff too.

May I Disable Serial Port at SUPER IO CHIP? Or May I Disable all serial ports shown at attached images corresponding to HD and more?

 

[Feartech]

May I Disable Serial Port at SUPER IO CHIP? Or May I Disable all serial ports shown at attached images corresponding to HD and more?

disable all serial ports

 

[JeQu]

disable all serial ports

IT WORKS!!! FINALLY!!!! THANKS MAN!!!!

 

[JeQu]

I have another question.
After installation program starts... several reboots are needed
May I remove install USB? When UEFI Clover booter appears again.... what option may I choose?

 

[Feartech]

I have another question.
After installation program starts... several reboots are needed
May I remove install USB? When UEFI Clover booter appears again.... what option may I choose?

sometimes a few reboots are required when installing macOS, it is normal