Hi folks, hoping to get some troubleshooting help. I'm getting the graphics-go-to-black-screen issue after what looks like a successful boot. This is after a Sonoma update.
I had a working OC 095 running Ventura on two NVMEs. It came from NATA's 088 updated using my best effort to 095.
I booted the backup drive, and updated to Sonoma (it gave me weird errors through System Settings -> update, but I downloaded the full package and it was fine). When I came back, I think it was booted up but at black screen. I wasn't sure what had happened, so I booted 095 to my primary drive, and installed Sonoma to the backup drive. When I came back, it was booted apparently cleanly to Sonoma, but IIRC wifi wasn't working (I have a wireless PCI card that allegedly is essentially the same as Apple hardware and is natively detected, "Broadcom BCM43xx 1.0 (7.77.111.1 AirPortDriverBrcmNIC-1766)" in system report), and drives other than the boot drive were not available, almost like it was in some sort of safe mode. Sound, ethernet, other stuff seemed ok.
But when I rebooted it black screened after boot.
I tried adding -v but it doesn't hang. It seems to boot up and goes to black screen. I should note it's a dual monitor setup.
I tried a 096 config I found on this thread, and it actually boots up to a logon screen! but after entering password, the screen went garbled, and then it black screened, didn't get to desktop.
The 096 config won't boot the Ventura drive, it hangs almost immediately.
I've attached the 095 config and the 096 config. Happy to provide any further details.
I guess first question, with the Radeon RX 6800 on Sonoma I assume I still need boot arg -wegnoigpu agdpmod=pikera? Just not with the RX 580 others are using? Perhaps I need to patch something for Sonoma for the RX 6800?
Thanks very much.